User manual WHIRLPOOL 20RU-D1L A INSTALLATION

[. . . ] Internal light (depending on the model) B. Snack drawer (depending on the model) E. Crisper drawer moisture control (where provided) G. Meat / crisper drawer temperature control (where provided) I. [. . . ] The value flashing on the freezer display is the the state of foodstuffs before consuming them. highest temperature reached during the power failure. Press the mute alarm button to switch off the acoustic signal. The This alarm may be activated when the appliance is used for the first appliance needs approximately 2-3 hours to reach the correct time. temperature to store a normal fridge load of food. Replace the filter (see the Quick Start Guide). Replace the filter (see the Quick Start Guide). To replace the filter, refer to the Instructions for Use. The "Anti-bacterial filter" symbol Anti-bacterial filter exhausted (if installed). The "Water filter" symbol has changed colour. Water filter running out/exhausted (where provided). The control panel is off and/or the appliance is not working There may be a problem with the power supply to the appliance Check that: • there has not been a power failure. • the plug is inserted properly into the power socket and the bipolar mains switch is in the right position (i. e. • the air ducts inside the compartments are not blocked, as this prevents the circulation of cold air. • the "Vacation mode" function is not enabled (see Quick Start Guide) If necessary, lower the temperature. The dispenser does not dispense ice when the lever is pressed. This is normal when the freezer door is open, or if the ice bucket is Close the freezer door and/or check that the ice bucket is installed not installed correctly. The "Child Safety" or "Ice/water dispenser lock" function may have been enabled. Disable the function (see the Quick Start Guide). Excessive moisture inside the compartments. It is not cold enough inside the compartments Change the ice selection from "ice cubes" to "crushed ice" or vice versa (in some models only), so as to remove any ice blocks. If the Ice cubes may be stuck because the ice dispenser has not been used dispenser continues not to dispense ice, wait for two minutes and for some time: The dispenser may not have been used for extended then repeat this operation. periods, causing the ice cubes to stick together. Shake the ice bucket to separate the cubes and increase the holding capacity. It is advisable to throw away the old ice and make new ice. There could be various causes The ice dispenser lever may have been pressed for too long. During the first delivery, there will be a delay of 15 to 20 seconds due to the system needing to fill with water. The dispenser does not dispense water when the lever is pressed. [. . . ] Disable the function (see the Quick Start Guide). Refer to the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call qualified personnel. Reactivate the function by pressing the anti-condensation switch in the ice/water dispenser area (marked with an arrow in the figure), depending on the model. [. . . ]