User manual WHIRLPOOL 20RU-D3L A /1 INSTALLATION

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. [. . . ] • The refrigerant system pipes are located near the defrost pan and can become very hot. Periodically clean them with a vacuum cleaner. Replacing light bulbs Attention • Always disconnect the refrigerator from the power supply before replacing any light bulbs. • Before replacing the light bulb, remove the light guard that may be present. This will have to be put back after replacing the light bulb. • The refrigerator accepts light bulbs with a bayonet type mount. • The ice/water dispenser light bulb has a standard screw type mount. Replace the lamp with one of the same type, available from the Aftersales Service or from authorised dealers. 16 GUIDE TO THE INSIDE PARTS FRESH FOOD COMPARTMENT (if available) The fresh food compartment has a tilting movement that facilitates the introduction and the removal of food. Opening, removal and replacing of the Fresh Food compartment. Open the Fresh Food compartment by pressing one of the buttons (1), while at the same time pulling the compartment as far as it will go. To remove the Fresh Food compartment proceed as above instructions and then lightly rotate and remove the compartment from it seat (2). Keep the glass near the dispenser outlet. Press lightly on the lever to activate the ice dispenser. Pressing hard will not result in faster dispensing or greater quantities. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass. Do not use fragile glasses. USING THE AUTOMATIC ICE-MAKER (if available) After switching on the refrigerator, it usually takes overnight for the first ice cubes to form. When selecting crushed ice, the cubes are crushed just before being dispensed, therefore the crushed ice may come out with a slight delay. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small amount of crushed ice may come out together with the first cubes. The quantity and size of the ice cubes depend on the mains water pressure. Ice cubes production can be increased by decreasing the temperature on the freezer compartment. ONLY FOR MODELS FITTED WITH ICE DRAWER Normal ice production consists of about 7 to 8 batches of ice cubes in a 24-hour period. [. . . ] If the dispenser still does not dispense ice, wait a couple of minutes and repeat the operation. If the dispenser does not dispense water when the lever is pressed: • During the first delivery, there will be a delay of 15 to 20 seconds due to the system needing to fill with water. • If the appliance is kept at very cold temperatures and the meat drawer temperature control shutter is open, water delivery might be temporarily interrupted. Closing the shutter will cause water delivery to recommence within the next 12 hours. [. . . ]