User manual WHIRLPOOL 20SI-L4 A PG INSTRUCTION FOR USE

[. . . ] 501931502021_GB 22-06-2007 8:31 Pagina 3 INSTRUCTIONS FOR USE BEFORE USING THE APPLIANCE SAFEGUARDING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS IF THE APPLIANCE IS NOT GOING TO BE USED MAINTENANCE AND CLEANING STORING, FREEZING AND THAWING FOOD DESCRIPTION OF THE APPLIANCE “MULTIFLOW” AIR DISTRIBUTION GUIDE TO THE INSIDE PARTS USING THE APPLIANCE USING THE ICE AND WATER DISPENSER USING THE AUTOMATIC ICE-MAKER CHANGING A WATER FILTER CARTRIDGE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE 3 501931502021_GB 22-06-2007 8:31 Pagina 4 BEFORE USING THE APPLIANCE Your new appliance is designed exclusively for domestic use. After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. [. . . ] When all the dashes disappear and the icon starts flashing, the filter needs replacing. Important: Only replace the antibacterial filter after all three dashes have disappeared from the filter icon. Replace the cartridge and press the OK button until the three dashes reappear on the display. Water filter This symbol indicates the state of the water filter. When switching on the appliance for first use, or after replacing the filter, the filter icon shows three dashes. In time their number will decrease, depending on the use of the appliance and the natural wear of the filter charge itself. When all the dashes disappear and the icon starts flashing, the filter needs replacing. Important: Only replace the cartridge after all three dashes have disappeared from the filter icon. Replace the cartridge and press the OK button until the three dashes reappear on the display. The water filter is located under the freezer compartment door. 13 501931502021_GB 22-06-2007 8:31 Pagina 14 USING THE APPLIANCE OPTIONAL FUNCTIONS Party mode This function is activated by pressing the menu button until the party mode symbol appears. With the symbol flashing, press OK to confirm your selection. This function enables to use the freezer compartment to cool drinks. When the function is selected, the icon is animated. 30 minutes after activation (the time needed to cool a standard 0. 75 litres bottle without breaking it), the icon will flash and the acoustic signal will come on. Remove the bottle and deactivate the function by pressing OK. Control panel lock function This function prevents accidental changing of appliance settings or switching off. The function is set by pressing the freezer temp and the fridge temp buttons at the same time for 3 seconds: the symbol will come on and an acoustic signal will activate. To deactivate the function, carry out the same procedure until the symbol goes off. Automatic ice-maker control panel lock This function consists of deactivating ice and water dispensing for easier cleaning or to prevent unintentional use. The function is set by pressing the ice mode and the light buttons at the same time for 3 seconds: the symbol will come on and an acoustic signal will activate. To deactivate the function, carry out the same procedure until the symbol goes off. Note: This function does not disconnect the power to the appliance, ice-maker or light, but simply deactivates the dispenser levers. Fast freezing (freezer) This function must be activated before freezing fresh food. [. . . ] Follow the instructions for the correct ice dispenser water supply. • Are the pipes correctly connected to the ice dispenser?The first ice cubes coming out of the dispenser may have an unpleasant taste, therefore it is advisable to discard them and make new ice cubes. If the dispenser does not dispense ice when the lever is pressed: • Change the ice selection from cubes to crushed ice, or vice versa, in order to remove any ice blocks. [. . . ]