User manual WHIRLPOOL 5GBB19PRYW PRODUCT FICHE

[. . . ] WARNING Indicates a hazardous situation which, if not avoided, could cause serious injury. All Safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. The appliance must be disconnected from the power supply before carrying out any installation work. Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations to the relevant gas standard. [. . . ] -- Models equipped with electrical ignition plugs and safety device require thorough cleaning of the plug end in order to ensure correct operation. Check these items frequently, and if necessary, clean them with a damp cloth. Any baked-on food should be removed with a toothpick or needle. NOTE: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing. Problem The electric ignition does not work The burner fails to ignite The gas ring burns unevenly Possible cause There is no electrical supply The gas tap could be closed Burner crown may be occluded by food residues Solution Check the unit is plugged in and the electrical supply is switched on. Check that the gas tap is open Clean the burner crown according to cleaning instructions to make sure that the burner crown is clear of food residues. Before calling the After-Sales Service: 1. Check “Troubleshooting guide” to see if you can eliminate the problem yourself 2. Turn the hob on again to check if correct operation has been restored. If the problem persists, contact the Aftersales Service. Give the following information: • type of fault; • hob model; • service number (i. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. -- After connection to the gas supply, check for leaks with soapy water. Light up the burners and turn the knobs from max position to minimum position check flame stability Electrical connection WARNING -- This operation must be performed by a qualified technician. -- The electrical connections must comply with local regulations. -- IMPORTANT: the data relevant to the voltage and power absorption are indicated on the rating plate. To A B C C -- Connect elbow (A) or (B) supplied with to the hob inlet main pipe and interpose the washer (C) supplied, in compliance with EN 549. -- Use elbow (A) for France and elbow (B) for all other destinations. Assembly After having cleaned the perimeter surface, apply the supplied gasket to the hob. Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction. NOTE: the power supply cable must be long enough to permit its upward extraction. To secure the hob, use the brackets provided with it. [. . . ] • Accidental damage caused by foreign objects or substances and cleaning or unblocking of filters , drainage systems or soap drawers. € Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. € Cases where no fault could be found during a technician’s visit. [. . . ]