User manual WHIRLPOOL 623 202 PROGRAM CHART

[. . . ] Remove and clean or change the filter regularly. € Never flame cook food (flambé) under the appliance. € The discharge air must not be discharged in ducts that are being used to discharge combustion fumes from gas heaters or heaters using any other combustible materials. The appliance must have its own dedicated discharge outlet. [. . . ] Ducting version The hood is equipped with a top air outlet B1 and with a back air outlet B2 for discharge of fumes to the outside (exhaust pipe and pipe fixing clamps not provided). 1 10 Filtering version In the case where it is not possible to discharge the cooking fumes and steam outside, the hood can be used in the filtering version, mounting 1 or 2 active carbon filters (*). The fumes and steam are recycled into the kitchen. 2 The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied). The connecting instructions are supplied with the peripheral suction unit. € • Installation Preparing for installation WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people. The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 70cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. ), eventually removing them and keeping them. In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). Choose the discharge outlet to use: Only filtering version: use ONLY the upper B1 outlet (Fig. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Before beginning installation: • Remove the fats filter/s or the suction grill/s (depending on the model in possession –see also the relative paragraph). This/these is/are to be mounted only if you want lo use the hood in the filtering version. Fix 2 hooks (*) R to the wall with screws and dowels. 7 In case the thickness of the lateral wall units is 16mm, put, with embedded fixing, the O (*) spacers at the sides of the hood in correspondence with the holes used for the passage of the fixing screws to the lateral wall units. Hang the hood onto the hooks (*) and adjust the position of the hood with headless screws S1 and adjusting the position of the hooking brackets with screws S2. 7 Fix the hood to the lateral wall units with 4 screws P. 8 Mount the lower corner Q (*) to the hood with two screws and plastic washers T. They will serve to cover possible spaces between the rear of the hood and the wall. 7 Operation Use the high suction speed in cases of concentrated kitchen vapours. [. . . ] cleaning WARNING: Never use steam cleaning equipment. Disconnect the appliance from the power supply. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. [. . . ]