User manual WHIRLPOOL 624 202 PROGRAM CHART

[. . . ] €¢ The appliance is designed solely for household use for cooking food products. The manufacturer declines any responsibility for damage due to improper use or wrong control settings. €¢ Any repairs or operations must only be carried out by a qualified technician. €¢ Do not expose the appliance to atmospheric agents. [. . . ] 1 and 2), then place them in a solution of hot water and nonabrasive detergent for about 10 minutes. After cleaning and washing the burners, carefully dry them. Always make sure that the openings are not blocked. It is advisable to carry out this operation at least once a week or whenever necessary. Make sure to properly refit the burners, turning them slowly so that the four sectors under the burner cap engage the injector holder seat (if perfectly centred, the burner lowers a little and locks in place). 2 Grid maintenance • Clean the grids with a sponge and detergent whenever they are dirty. • The grids will change colour near the burners. This is perfectly normal and is due to the high temperature reached during cooking. Oven cleaning • After finishing cooking, wait for the oven to cool, then clean it to prevent the accumulation of cooking residuals. €¢ For stubborn dirt, use a specific oven cleaning product following the instructions given on the package. €¢ Clean the outside of the oven with a sponge and tepid water. 6 ENGLISH 22 Gas connection For information regarding gas connection instructions, see the injectors table and the “standard” relevant to your country. The gas supply system must comply with current local regulations. The appliance must be connected to the gas supply or gas bottle by means of a rigid copper, steel pipe or rubber hose based on local regulation (see gas connection table). The hose must be connected directly to the outlet connector (Fig. 1), after first of all ensuring you remove any extension cable fitted to your appliance. When the appliance is connected to the gas supply, use soapy water to check for gas leaks. The rubber hose must be connected as shown in Fig. 3, 4 and 5, in compliance with local applicable regulations FOR FRANCE ONLY: do not install the conical fitting (B) supplied on the appliance. The rubber hose must be connected to the outlet connector and secured using hose clamp (C) (Fig. 1 IMPORTANT: when using a rubber hose, it must be installed in such a way as not to be in contact with hot parts on the rear of the appliance or kitchen. It must pass through an area free of any hindrances and in a place where it can be inspected along its entire length (Fig. [. . . ] • Consumable parts including batteries and lamps. €¢ Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible color differences. • Accidental damage caused by foreign objects or drainage systems or soap drawers. €¢ Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. [. . . ]