User manual WHIRLPOOL 63851343

[. . . ] Turn the corresponding control knob anticlockwise until the indicator coincides with the maximum flame symbol . Press the control knob to ignite the burner. Once the burner has lit, keep the control knob pressed for about 5 seconds to allow the safety thermocouple fitted to each burner to engage. The thermocouple will switch off the gas supply to the burner should the flame be accidentally lost (A gust of air, momentary interruption of gas supply or liquid spillage etc). [. . . ] Warning · Keep children away from the hob when in use and don't let them play with the control knobs or any other part of the appliance. · Do not let children play with the pan supports. The rubber feet on the underneath of the pan supports could be swallowed by small children and cause serious injury or suffocation. · Before replacing the pan supports on the hob, please check that all the rubber feet are in place. · Each time you finish using the hob, always check that the control knobs are in the off position and shut off the tap to the gas mains or cylinder. · Do not obstruct the air vents at the back of the appliance in any way. 22 INSTALLATION (FLUSH AND TRADITIONAL FITTING) Technical information for the installer · This appliance can be installed into a 20 mm 50 mm thick worktop. · If no oven is to be installed below the hob, a panel must be fitted under the hob to prevent hob damage and protect the cupboard contents. This panel must cover the whole of the underside of the hob and must be positioned so that an air gap of at least 50 mm between the panel and hob underside is maintained, as a minimum, and as a maximum 150 mm to the underneath of the work surface. · This hob is designed to operate perfectly with any oven in the Whirlpool range. The Manufacturer declines all responsibility should another make of oven be installed. Before installation, please ensure that: · The gas supply (type and pressure) and the calibration on the hob are compatible (see serial number plate on the hob and the injector table). Apply a light but firm pressure to ensure a good adhesion to the work surface. Fix the hob into the unit, and secure using the fixing brackets provided. Note: the electrical power cable must be long enough to allow the hob to be lifted out from above. 24 FIXING THE HOB TO THE WORK TOP. FLUSH FITTED MODEL Important: The following procedure must be carried out by competent technical personnel only. The hob can be installed on, or into different types of materials, such as masonry, metal, wood and heat resistant laminate coated wood (90°C). Cut an opening in the worktop to the dimensions shown in the diagram. R. 11 860 51 0 80 861 848 49 8 51 1 Fig. 1 Note: For laminated worktops with a laminate thickness of less than 3 mm, create a recess as shown as on the detailed schematic drawing. Before positioning the hob, apply the adhesive gasket/seal supplied, on the underneath edge of the hob itself, where the hob will be in contact with the worktop (fig. Once the seal is in place, place the hob into the recess. Secure the hob into the work surface using the screws and brackets provided, tightening them until the hob is perfectly flush (fig. Carefully trim off the excess gasket/seal. [. . . ] · Do not leave acidic or alkaline based products like vinegar, mustard, salt, sugar or lemon juice lying on the hob, as this will damage the hob and 'etch' the glass surface. Note: With time, regular use of the hob could cause some discolouration around the burners. This is caused by the high temperature of the flame and will not affect the operation or performance of the hob. CARE AND MAINTENANCE OF THE GAS BURNERS The pan supports and burners can be removed to make cleaning easier. Hand wash carefully in hot water with a mild detergent making sure that all the ingrained dirt is removed and the openings on the burner are not blocked. [. . . ]