User manual WHIRLPOOL 6AKM 331/IX INSTRUCTION FOR USE

[. . . ] Packaging The packaging material is entirely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres. d 2. Product The cooking hob is made out of recyclable material. [. . . ] x Do not use abrasive or corrosive products, chlorine products or steel wool. x Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the cooking hob. Stainless steel surface x Clean it with a specific commercial product. Note: if the cooking hob is used continuously, the high temperatures may alter the colour of the hotplates. x Cleaning the electric hotplates The electric hotplates must be cleaned when they are lukewarm. Wipe them with a cloth moistened with water and salt, and polish with a cloth moistened with oil. 10 M 10 Y N AFTER-SALES SERVICE Before you call the After-sales Service: 1. Re-start the cooking hob, to check whether correct operation has been restored. If the malfunction persists, call the After-sales Service. Give the following information: x type of malfunction; x model of cooking hob; x service number (i. e. , the number that follows the word SERVICE on the rating plate under the cooking hob and on the guarantee paper); x your complete address; x your telephone number and area code. INSTALLATION Technical information for installer This cooking hob can be embedded in a worktop 20 to 50 mm thick. If another appliance is not fitted under the cooking hob, insert a separator panel, at a distance of at least 90 mm from the cooking hob bottom. x If a vertical piece of furniture is installed, there must be a gap of at least 00 mm between it and the edge of the cooking hob. x x Before installing the cooking hob, remove the plastic film that protects it, if present. The outer surfaces of the furniture or appliances adjoining the cooking hob must be heat resistant (heat protection “Y”, according to standards EN 60335-2-6). Installation must comply with current local safety regulations. l C Installation of cooking hob x Apply the supplied gasket to the cooking hob (unless it has already been fitted), after having cleaned its surface as shown in the figure. - If the worktop is made out of wood, use the springs supplied. [. . . ] Peel off the internal cables for about 10 mm, loosen cable clamp screw , and insert the cable in the cable clamp. x The terminal board has 4 terminals: 1-2 interconnected (line) 3 (neutral) 4 (earth): marked with symbol . [. . . ]