User manual WHIRLPOOL 8206555-D-WH

[. . . ] ® Microwave Hood Combination OVERALL DIMENSIONS PRODUCT MODEL NUMBERS MH1160XS MH1170XS MH2175XS Electrical: A 120-volt, 60 Hz, AC-only, 15 or 20 amp electrical supply located in the upper cabinet as close as possible to the microwave oven hood. A time-delay fuse or circuit breaker and separate circuit is recommended. 17¹/" (43. 5 cm) 15/" (40. 3 cm) 15 (39 ³/" . 1 c m) 29/" m) (75. 9 c CABINET OPENING DIMENSIONS Space between cabinets must be 30" (76. 2 cm) minimum and be free of obstructions. [. . . ] (1. 8 m) B Recommended standard fittings 3-1/4" x 10" to 6" = 5 ft. 3-1/4" x 10" roof cap = 24 ft. 3-1/4" x 10" 90° elbow = 25 ft. 90° elbow 6" = 10 ft. 3-1/4" x 10" wall cap = 40 ft. 45° elbow 6" = 5 ft. 3-1/4" x 10" flat elbow = 10 ft. For wall or roof venting methods: If the wall exhaust method is chosen, be sure that there is proper clearance within the wall for the exhaust vent. Wall and roof caps must have back-draft damper. that length of vent and number of elbows should be kept to a minimum to provide efficient performance. using duct tape to seal all joints in the vent system. using caulking compound to seal exterior wall or roof opening around cap. two elbows should not be installed together. We do NOT recommend: flexible metal vent. NOTE: If flexible metal vent must be used, calculate each foot of flexible metal vent as two feet of rigid metal vent. Flexible metal elbows count twice as much as standard elbows. 2 ft. 1 - 3-1/4" x 10" (8. 3 x 25. 4 cm) 90° elbow = 25 ft. [. . . ] For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. [. . . ]