User manual WHIRLPOOL 830202 PROGRAM CHART

[. . . ] countertop thickness Top view of cabinet cutout Proper installation is your responsibility. Have a qualified technician install this range. Range location should be away from strong draft areas, such as windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used. [. . . ] Do Not have a fuse in the neutral or ground circuit. This range must be connected to a grounded metal, permanent wiring system. Range must be connected to the proper electrical voltage and frequency as specified on the model/serial rating plate. (The model/serial rating plate is located on the oven door or on the oven frame. ) Models rated from 11. 8 kW to 13. 3 kW at 240 volts (8. 9 kW to 10. 0 kW at 208 volts) require a separate 40-ampere circuit. A time-delay fuse or circuit breaker is recommended. Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or non-metallic sheathed, copper cable (with ground wire). Flexible armored cable from appliance should be connected directly to junction box. A U. L. -listed conduit connector must be provided at the junction box. Wire sizes and connections must conform with the rating of the appliance and to the requirements of the National Electrical Code, ANSI/NFPA 70 -- latest edition (** See Page 1) and all local codes and ordinances. If the house has aluminum wiring, follow the procedure below. a. ) Connect the aluminum wiring to the copper wire using special connectors designed and Underwriters Laboratories-listed for joining copper to aluminum. Set trim and screws aside on protected surface. 3. Remove Page 2 B Electrical connection If your house has aluminum wiring, see "Electrical requirements" Page 2. , junction box red wires white wire cable from power supply black wires junction box red wires cable from power supply white wires WARNING Electrical Shock Hazard Turn power supply off before connecting wires. Failure to follow these instructions can result in death, fire, or electrical shock. This range is manufactured with white (neutral) power supply wire and a cabinet-connected bare ground wire twisted together. Make electrical connection following the steps needed for your installation. Connect range cable to junction box through the U. L. -listed conduit connector. Connect the two black wires together with twist-on connectors. Connect the two red wires together with twist-on connectors. Complete electrical connection according to local codes and ordinances. white and bare ground range cable wires -- factory crimped Figure 1 cable from range U. L. -listed conduit connector bare ground wires black wires U. L. -listed conduit connector Figure 2 cable from range If local codes PERMIT connecting cabinet-ground conductor to neutral white wire in junction box: 7. Connect the factory-crimped bare and white range cable wires to the neutral (white) wire in junction box. Replace junction box cover. If local codes DO NOT PERMIT connecting cabinet-ground conductor to neutral white wire in junction box: 7. [. . . ] Close and open the door to check that the door closes and opens completely. If door does not close or open completely, repeat the door removal step and reinstall door as described above. shipping foot To avoid damaging the countertop, lift range slightly while pushing against seal area of front frame. Push range into cabinet cutout until shipping feet almost contact cabinet. Use a Phillips screwdriver to remove screws attaching shipping feet. [. . . ]