User manual WHIRLPOOL 8572777

[. . . ] 27" (69 CM) GAS WASHER/DRYER INSTALLATION INSTRUCTIONS Table of Contents WASHER/DRYER SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 INSTALLATION INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . 2 Tools and Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Alternate Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Look for the words "CUT HERE. " Discard end with cotter pins. You will use the remaining piece of shipping strap to secure the drain hose. 7 Install Leveling Legs Install the front leveling feet 1. Prop up the front of the washer/dryer about 4" (10. 2 cm) with a wood block or similar object. The block needs to support the weight of the washer/dryer. Screw the locknut onto each foot to within 1" (2. 5 cm) of the base. 4. Twist hose back and forth while pushing onto drain connector on the side of the washer/dryer. Continue until hose contacts the ribbed stops on the cabinet. 1" (2. 5 cm) 3. Screw the feet into the correct holes at the front corner of the washer/dryer until the nuts touch the washer. NOTE: Do not tighten the nuts until the washer/dryer is level. Tilt the washer/dryer back and remove the wood block. Gently lower the washer/dryer to the floor. 5. Place clamp over the area marked "CLAMP. " Release clamp. For laundry tub or standpipe drain systems 1. Open the yellow single-wire clamp and slide over the hooked end of the drain hose to secure the rubber and corrugated sections together. For mobile home use Washer/dryers with gas dryers must be securely fastened to the floor. A B Mobile home installations require a Mobile Home Installation Kit. See "Tools and Parts" section for ordering information. A. Drain hose Connect the Drain Hose Proper connection of the drain hose protects your floors from damage due to water leakage. To prevent the drain hose from coming off or leaking, it must be installed according to the following instructions: IMPORTANT: To ensure proper installation, this procedure must be followed exactly. Check the drain hose to see whether it is the proper length. Wet the inside of the straight end of the drain hose with tap water. IMPORTANT: Do not use any lubricant other than water. Squeeze ears of the silver, double-wire clamp with pliers to open. Place clamp over the straight end of the drain hose ¼" (6. 4 mm) from the end. 2. Put hooked end of drain hose into laundry tub or standpipe. [. . . ] All connections must be wrench tightened. The valve is open when the handle is parallel to the gas pipe. 1. If there is an extra part, go back through the steps to see which step was skipped. Dispose of/recycle all packaging materials. [. . . ]