User manual WHIRLPOOL 9762998

[. . . ] INSTALLATION INSTRUCTIONS 30" (76 CM) FREESTANDING GAS RANGES Table of Contents RANGE SAFETY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 INSTALLATION REQUIREMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Tools and Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Location Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electrical Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Place burner grates over burners and caps. F. ½" or ¾" gas pipe H. Burner grate A Typical flexible connection 1. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in following illustration). Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Use a ¹/" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked. WARNING A B C D E Electrical Shock Hazard Plug into a grounded 3 prong outlet. Adapter (must have ½" male pipe thread) D. Flexible connector G F Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 5. Plug into a grounded 3 prong outlet. E. ½" or ¾" gas pipe G. Check that the gas pressure regulator shutoff valve is in the "on" position. Electronic Ignition System Initial lighting and gas flame adjustments Cooktop and oven burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the "LITE" position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to "LITE. " When the oven control is turned to the desired setting, sparking occurs and ignites the gas. A A. Gas pressure regulator shutoff valve 8 Check Operation of Cooktop Burners Standard Surface Burners Push in and turn each control knob to the "LITE" position. The flame should light within 4 seconds. The first time a burner is lighted it may take longer that 4 seconds to light because of air in the gas line. Check Operation of Oven Bake Burner 1. To remove the oven bottom: Remove 2 screws at the rear of the oven bottom. Lift the rear of the oven bottom up and back until the front of the panel is away from the front frame. Remove from oven and place the cover on a protected surface. If burners do not light properly: s s s s Turn cooktop control knob to the "OFF" position. Check that the circuit breaker has not tripped or the household fuse has not blown. [. . . ] Use a ½" combination wrench to loosen the orifice hood away from the pin (about 2 to 2½ turns). The oven bake burner flame cannot be properly adjusted if this conversion is not made. See "Adjust Oven Bake Burner Flame" section. B A D C A D A C B A. Natural gas: increase gas - increase flame size (preset at factory for Natural gas). [. . . ]