User manual WHIRLPOOL ACM 300 BR PROGRAM CHART

[. . . ] Be extremely vigilant when cooking food with boiling oil or fat since these can catch fire. In the event of oil catching fire, never attempt to put it out with water: switch the hob off and cover the pot immediately with a lid; leave the pot on the cooking zone to cool down. Dispose of the oil in compliance with current regulations. When you finish cooking, press button . Precautions and Advice 1. [. . . ] Secure the power cable with the cable clamp. Close the cover (C) and screw it on the terminal block with the removed screw - point (1). Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds. 400V 3N ~ 230V ~ 230-240V~FOR AU ONLY 230V~FOR UK ONLY 230V 230V 230V 230V 400V 2N ~ 230V 3~ ONLY FOR BELGIUM 400V 2N~ FOR NL ONLY 230V 230V A 230V 230V B C 4 230V 230V 230V Installation and fixing The installer is responsible for any damage or injury resulting from incorrect installation. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. For cut-out dimensions, see the figure below. Dimensions in mm 580 510 +1 0 The worktop must be -20 50mm thick. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any chips that could compromise appliance operation. 770 510 +1 0 483 553 min. 50 +2 0 52 483 52 742 R min. 8 +2 0 490 560 490 750 For flush mounted installation or setting into a marble worktop, contact the After-sales Service for the installation kit and necessary instructions. • 4812 310 19277 Installation kit for marble worktop. • 4801 211 00112 Installation kit for flush fitted worktop. After 10 minutes' use of the booster function, the appliance automatically sets the zone to level 9. display shows “0:0” or press the buttons “+” and “-” of the timer at the same time. The timer function can only be used with one cooking zone at a time. Switching off cooking zones Select the cooking zone to be switched off by pressing the “+” or “-” key (a dot lights up at the bottom right hand side of the heat setting indicator). Press the key “-” to set the level to “0”. The cooking zone can also be switched off by pressing keys “+” and “-” at the same time. The cooking zone switches off and the residual heat indicator “H” lights up Minute minder The minute minder can only be used when the hob is not in use and allows a maximum setting of 99 min. Press the button “+” below the timer indicators: the display shows the minutes for setting. Select the time desired using the buttons + and -. After a few seconds the minute minder starts to count down. Once the set time has elapsed an acoustic signal sounds. Child safety This function locks the hob controls to prevent accidental switching on by children. To activate the child safety function, switch on the hob then press and hold the button for three seconds: an acoustic signal and a luminous indicator under the key symbol signal activation. [. . . ] A few seconds after the button is pressed, the timer begins the countdown (the luminous dot of the selected cooking zone starts flashing). Once the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically. To deactivate the timer, press the button “-” until the Incorrect or missing pot indicator. The hob features an automatic pot detection system for all cooking zones. If no pot is detected, the display with the cooking zone power level indicator flashes. [. . . ]