User manual WHIRLPOOL ACM 708/NE INSTRUCTION FOR USE

[. . . ] • The installer is responsible for the correct electrical connection of the oven and the observance of the relative safety regulations. • The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. • Do not use multiple plug adapters or extension leads. • After the oven has been installed, the electrical components must be inaccessible. [. . . ] • During the cooking process water evaporates as steam from the food. All ovens require this steam, and other fumes, to be vented from the oven cavity. For reasons of safety and appearance, it was determined that the bottom of the door is the optimum position. Consequently vapour may be seen coming from this area on occasion (see picture). This is a normal occurrence and the bottom trim can be cleaned. • Do not rest heavy weights on the door because these could damage the oven cavity and the hinges. Maximum weight: 7 Kg. • Do not cover the bottom of the oven with aluminium foil. Fum es E x hau st 7 3gb66002a. fm5 Page 8 Wednesday, April 3, 2002 2:32 PM OVEN ACCESSORIES • Accessories supplied depend on the model (refer to the Product Description Sheet supplied separately). Bar rack The bar rack can be used in the same way as a flat rack. The number of shelf positions can be doubled, depending on whether the rack is inserted in the (A) or (B) position. Multi-purpose drip tray This tray can also be used as a baking tray, and has a sloping edge for this purpose. Use as a baking tray for cream puff, meringues, madeleines, puff pastry, etc. When placed under a rack, it acts as a drip tray to collect dripping juices and fat from grilling dishes. Turnspit The turnspit comes supplied with a stand for the spit. To use the turnspit: • Fit the spit stand in position in the oven. Once the internal temperature of the oven exceeds the maximum cooking temperature, the door can no longer be opened. 9 3gb66002a. fm5 Page 10 Wednesday, April 3, 2002 2:32 PM CLEANING THE OVEN AND ITS ACCESSORIES Notes The self-cleaning function can be operated at any time using the programmer, even overnight (to take advantage of lower tariffs). Before operating, take the following essential precautions: • remove all accessories from the oven, including the oven fittings (racks, multifunction drip trays, etc. ). • remove larger deposits, since these can ignite or produce a large amount of smoke. When the self-cleaning operation is complete and the door can be re-opened, there may be white deposits on the inside of the oven: allow the oven to cool and remove any residues with a damp sponge. The cooling fan will continue to operate after the oven has switched off. This is normal, and it will switch off automatically once the oven has cooled down to normal temperature. is selected automatically and cannot be modified. A delayed self- cleaning cycle can be programmed; please refer to the instructions in the separate Programmer Sheet, section: Selecting the End of Cooking time. In ovens with electronic control: a time of 1h. To change this time or select delayed selfcleaning, please refer to the separate Programmer sheet, section: Selecting the Cooking Time or Selecting the end of Cooking Time. In ovens without electronic control, the selfcleaning time must be programmed. [. . . ] If the appliance still fails to function properly, please call After Sales Service. AFTER SALES SERVICE • Before contacting AFTER SALES SERVICE: 1. See whether you can solve the problem yourself (see “Trouble-shooting guide”). Switch the appliance off and on again to see whether the problem has disappeared. If after these checks the oven is not working correctly, contact the nearest After-Sales Service. [. . . ]