User manual WHIRLPOOL ACM 739/NE INSTRUCTION FOR USE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual WHIRLPOOL ACM 739/NE. We hope that this WHIRLPOOL ACM 739/NE user guide will be useful to you.

Lastmanuals help download the user guide WHIRLPOOL ACM 739/NE.


Mode d'emploi WHIRLPOOL ACM 739/NE
Download
Manual abstract: user guide WHIRLPOOL ACM 739/NEINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] - Do not use multiple plug adapters or extension leads. - Do not pull the power cable to disconnect it from the electrical supply. - The electrical components must not be accessible to the user after installation. - Do not touch the appliance with wet parts of the body or use it when barefoot. [. . . ] This could result in damage. RECOMMENDED DIAMETERS OF POT BOTTOMS XL Ø 30 cm Ø 24 cm Ø 18 cm Ø 14 cm Ø 17 cm Ø 14 cm 18 cm 24 cm L 30 cm XL Ø 26 cm Ø 21 cm Ø 14. 5 cm 18 cm 14 cm (Dual zone) Ø 26 cm Ø 15 cm Ø 11 cm 14. 5 cm 21 cm L M M GB12 31901497. book Page 13 Friday, May 29, 2009 12:45 PM INSTALLATION After unpacking the hob, check that there has been no damage during transport. If in doubt, contact the dealer or After-sales Service. PREPARING THE HOUSING UNIT Install a separator panel under the hob. The lower part of the product must not be accessible after installation. - If there is an oven beneath the hob, do not install the seperator panel. For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure. Do not obstruct the minimum required clearance between the hob and the top of the unit to ensure the correct operation of the product. Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust. WARNING - min. 5 ELECTRICAL CONNECTION Disconnect the appliance from the mains power supply. The appliance must be installed by a qualified technician who is fully aware of current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power supply cable must be long enough to allow the hob to be removed from the worktop. Make sure the voltage specified on the appliance rating plate is the same as that of the house electrical system. Do not use extension leads. WARNING - - Connecting to the terminal board For electrical connection, use an H05RR-F cable as specified in the table below. Conductors 230 V ~ + 230-240 V ~ + 230 V 3 ~ + 400 V 3N ~ + 400 V 2N ~ + Amount x size 3 x 4 mm 2 400 V 3N ~ 230 V ~ 230-240 V ~ (Australia only) 230 V ~ (UK only) 3 X 4 mm2 (Australia only) 230 V 230 V 230 V 230 V 5 X 1. 5 mm2 4 X 1. 5 mm2 A B C 400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only) 230 V 230 V Connect the yellow/green earth wire to the terminal with the symbol . This wire must be longer than the other wires. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B). 70 mm of sheath from the power supply cable. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself. Secure the power cable with the cable clamp. Close the cover (C) and screw it on the terminal block with the removed screw - point (1). Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds. If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an allpole disconnect switch with minimum contact gap of 3 mm. GB13 230 V 230 V 230 V 230 V 230 V 4 X 1. 5 mm2 31901497. book Page 14 Friday, May 29, 2009 12:45 PM INSTRUCTIONS FOR USE Control Panel Description The control panel is equipped with touch controls: to use them, just press the corresponding symbol (it is not necessary to press hard). [. . . ] Turn the hob off and on again to check if the problem has been eliminated. If after the above checks the fault persists, contact the nearest After-sales Service. Always specify: • a short description of the fault; • the type and exact model of the hob; • the Service number (the number after the word Service on the rating plate) located under the appliance (on the metal plate). The Service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL ACM 739/NE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL ACM 739/NE will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag