User manual WHIRLPOOL ACM 744/BA INSTRUCTION FOR USE

[. . . ] - Do not use multiple plug adapters or extension leads. - Do not pull the power cable to disconnect it from the electrical supply. - The electrical components must not be accessible to the user after installation. - Do not touch the appliance with wet parts of the body or use it when barefoot. [. . . ] The lower part of the product must not be accessible after installation. If there is an oven beneath the hob, do not install the seperator panel. min. 5 • • • For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure. Do not obstruct the minimum required clearance between the hob and the top of the unit to ensure the correct operation of the product. Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust. ELECTRICAL CONNECTION Disconnect the appliance from the mains power supply. The appliance must be installed by a qualified technician who is fully aware of current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power supply cable must be long enough to allow the hob to be removed from the worktop. Make sure the voltage specified on the appliance rating plate is the same as that of the house electrical system. Do not use extension leads. WARNING - - Connecting to the terminal board For electrical connection, use an H05RR-F cable as specified in the table below. Conductors 230 V ~ + 230-240 V ~ + 230 V 3 ~ + 400 V 3N ~ + 400 V 2N ~ + Amount x size 3 x 4 mm2 3 X 4 mm2 (Australia only) 4 X 1. 5 mm2 5 X 1. 5 mm2 4 X 1. 5 mm2 400 V 3N ~ 230 V ~ 230-240 V ~ (Australia only) 230 V ~ (UK only) 230 V 230 V 230 V 230 V A B C 400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only) 230 V 230 V 230 V 230 V Connect the yellow/green earth wire to the terminal with the symbol . This wire must be longer than the other wires. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B). 70 mm of sheath from the power supply cable. Insert the power supply cable into the cable clamp and connect the wires to the terminal board as indicated in the diagram next to the terminal board itself. Secure the power cable with the cable clamp. Close the cover (C) and screw it on the terminal block with the removed screw - point (1). Each time the cooktop is connected to the mains it carries out an automatic check which lasts several seconds. If the hob already has a power cable, follow the instructions given on the label attached to the cable. Connect the appliance to the electricity supply by means of an allpole disconnect switch with minimum contact gap of 3 mm. GB14 230 V 230 V 230 V 501931902055. book Page 15 Thursday, June 4, 2009 4:21 PM INSTRUCTIONS FOR USE Control Panel Description The control panel is equipped with touch controls: to use them, just press the corresponding symbol (it is not necessary to press hard). To select and activate the cooking zones Hob ON/OFF To set the minute counter To enable the hold function To lock the control panel To select one of the automatic functions Slide touch screen First use / after a power failure After connecting the hob to the electrical power supply, the control panel is locked (the indicator light above the key is ON). To unlock the control panel, press and hold the key for 3 seconds. The indicator light switches off and the hob can be used normally. Switching the hob ON/OFF To switch the hob on, press and hold the key for approx. [. . . ] The Service number is also indicated on the warranty booklet; • your full address; • your telephone number and area code. Attach here one of the two appliance data plate stickers found in the warranty booklet. If any repairs are required, please contact an authorised After-Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). GB17 501931902055. book Page 18 Thursday, June 4, 2009 4:21 PM POWER LEVEL TABLE Power level Type of cooking Level use (indicating cooking experience and habits) Ideal for rapidly increasing the temperature of food to fast boiling in the case of water or rapidly heating cooking liquids Ideal for browning, starting to cook, frying deep frozen products, fast boiling Max. power Boost 8-9 7-8 Fast heating Frying - boiling High power 6-7 4-5 Medium power 3-4 2-3 1-2 Low power 1 Zero power Browning - sautéing - boiling Ideal for sautéing, maintaining a lively boil, cooking and grilling (for a short period of time, - grilling 5-10 minutes) Browning - cooking - stewing Ideal for sautéing, maintaining a light boil, cooking and grilling (for a medium period of time, - sautéing - grilling 10-20 minutes), preheating accessories Cooking - stewing - sautéing Ideal for stewing, maintaining a gentle boil, cooking (for a long period of time). Creaming pasta grilling Cooking - simmering thickening - creaming Melting - thawing Keeping food warm creaming Support surface Ideal for long-cooking recipes (rice, sauces, roasts, fish) with liquids (e. g. [. . . ]