User manual WHIRLPOOL ACM 808/NE

[. . . ] DE12 IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and always observed. This is the danger symbol, regarding safety, warning of potential risks to users and others. All safety messages will be preceded by the danger symbol and the following words: DANGER WARNING Indicates a hazardous situation which, if not avoided, will result in serious injury. Indicates a hazardous situation which, if not avoided, could cause serious injury. [. . . ] Some cooking zones have a fast boil function (Booster), shown on the display with the letter “P”. Press the corresponding button (a dot lights up at the bottom right of the power level indicator). Press the key “-” to set the level to “0”. To switch off instantly, hold the zone selection button for 3 seconds. The cooking zone switches off and the residual heat indicator “H” lights up. Control panel lock This function locks the controls to prevent accidental switching on of the hob. To activate the control panel lock function, switch on the hob and hold button (or the Automatic function/Eco Booster button, where present) for three seconds; an acoustic signal and a luminous indicator next to the padlock signal activation. The control panel is locked except for the deactivation function. To deactivate the control panel lock, repeat the activation procedure. The luminous dot goes off and the hob is active again. The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock function. Timer The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all cooking zones. Select the cooking zone to be used with the timer (an illuminated dot appears to the bottom right hand side of the heat setting indicator on the display), press the button with the clock symbol then set the desired cooking time using the buttons “+” and “-” of the timer function (see figure). After a few seconds, the timer begins the countdown (an illuminated dot is visible next to the zone for which the timer has been activated). Once the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically. To deactivate the timer, press the “-” button until the display shows “0:0” or hold the button with the clock symbol for at least 3 seconds. To set the timer for another zone, repeat the points above. The timer display always shows the timer for the selected zone or the shortest timer. To change or switch off the timer, press the zone selection button for the timer in question. The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot. If the display shows , the cooking zone is still hot. [. . . ] DK91 - Hvis der er en revne i overfladen, skal stikket tages ud af stikkontakten for at undgå risikoen for elektrisk stød. Eksempel på tilstedeværende bro på plads (til venstre) eller aftaget bro (til højre). se forbindelsesdiagrammet for detaljer (broerne kan sidde mellem L1-L2 og mellem N1 og N2). DK94 230 V 230 V 230 V 230 V 230 V BRUGERVEJLEDNING Beskrivelse af betjeningspanelet Betjeningspanel Tænding/slukning Timer Låsning af betjeningspanel A Betjeningsfunktioner og display for kogezone Tænding/slukning Timer Låsning af betjeningspanel “Modeller med flex-zonefunktion” B Tast til automatisk funktion/ Ecobooster Betjeningsfunktioner og display for kogezone Tænding og slukning af kogesektionen Kogesektionen tændes, ved at der trykkes på tasten i 2 sekunder, indtil kogezonens display lyser. [. . . ]