User manual WHIRLPOOL ACM 925 WH INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE INSTALLATION INSTRUCTIONS BEFORE USING THE APPLIANCE PRECAUTIONS AND GENERAL ADVICE ENERGY SAVING TIPS OVEN ACCESSORIES CLEANING AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE For best use of the oven, carefully read the operating instructions and keep them for future consultation. 88 INSTALLATION INSTRUCTIONS Electrical connection Before connecting the appliance, make sure: 1. the mains voltage in your home matches that specified on the appliance dataplate; 2. the electrical system adequate for appliance max. power absorption specified on the dataplate; 3. [. . . ] For appliances equipped with Flame Failure Devices and microswitches, the control panel must be removed in order to safely access the adjusting screw. To adjust the minimum flame, proceed as follows • Light the burner and turn the knob to min. Insert a small screwdriver in the tap pin (Fig. Turn the adjustment screw anticlockwise to increase the flame, or clockwise to decrease it. Adjustment is correct when the flame is approx. The adjustment screw must be completely screwed down for butane/propane gas. Make sure the flame does not go out when switching straight from high to low flame and vice versa. 7 93 Oven minimum flame adjustment Light the oven burner at max. 20 minutes (at least to obtain first activation of the thermostat), proceed as follows: remove the oven knob and insert a small screwdriver under the thermostat, as shown in the figure. Turn the adjustment screw clockwise to increase the flame and anticlockwise to decrease it. For correct setting, make sure the flame height is 3/4 mm. BEFORE USING THE APPLIANCE • Remove the accessories from the oven and heat it at 200°C for about two hours to eliminate the smell of protective grease and insulating materials. Keep the window open during this operation. • Before use, remove: - stickers located on the front of the appliance and on the oven door, except the dataplate; - cardboard protection and protective plastic film on the control panel and other parts of the appliance; - any stickers on the accessories (e. g. Packing The packing material is completely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the appliance or accompanying documentation indicates that this product must not be treated as household waste, but must be taken to a collection centre for the recycling of electrical and electronic appliances. Disposal must be carried out in accordance with the local environmental regulations on waste disposal. For more detailed information about the treatment, recovery and recycling of this product, please contact your competent local authority, the household waste collection service or the shop where you purchased the appliance. 94 PRECAUTIONS AND GENERAL ADVICE • The appliance is designed solely for domestic use for cooking food. • Make sure the electrical cables of any other appliances used near the oven do not touch hot parts or get caught in the oven door. • Do not place flammable materials in the oven or nearby, due to the risk of fire if the oven is inadvertently switched on. • Use oven gloves to remove pans and accessories when the oven is hot. [. . . ] Carefully follow these instructions to prevent injury and/or damage to the oven door and hinges. Pay attention to the oven door hinges: risk of injuring hands! saddle bracket (see detail A) saddle bracket DETAIL A Open the oven door Fully open the saddle brackets While opening the saddle brackets, use a metal tool such as handle side of a spoon for easy opening. NOTE: Proceed in reverse order to refit the door. Make sure the saddle brackets are lowered before closing the oven door. [. . . ]