User manual WHIRLPOOL ACM 935/1 WH INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE INSTALLATION INSTRUCTIONS USE AND MAINTENANCE BEFORE USING THE APPLIANCE PRECAUTIONS AND GENERAL ADVICE OVEN ACCESSORIES CLEANING AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE For best use of the oven, carefully read the operating instructions and keep them for future consultation. 4 INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTION This appliance must be earthed by law. Before connecting the appliance to the electrical supply, check that the earth system in your house is working correctly. Check that unit voltage and power, marked on the rating plate applied on the appliance, are correct for the supply. It is necessary that the feeding network is protected by a powerful switch able to disconnect completely the network with a contacts separation of at least 3 mm. [. . . ] USING GAS BURNERS The following symbols are on the control panel next to each knob: Black circle Large flame Small flame gas off maximum setting minimum setting APPLIANCES WITH SAFETY VALVE (depending on the models) Follow the same procedure described above to ignite the burners. In this case, however, once you have turned the knob to the open setting, hold it pressed in for 10 seconds. If for any reason the burner flame goes out, the safety valve automatically shuts off the gas supply to the burner in question. ENERGY SAVING TIPS The diameter of the pan bottom should be the same as that of the burner. The burner flame must never come out from the pans diameter. • Whenever possible, keep a lid on the pan while cooking. In this way the safety valve will be started up. If for any reason the burner flame goes out, repeat the procedure as described above. When you will be sure that the burner is on, close softly the oven door. To obtain the desired temperature, turn the knob index to the selected number (See Fig. 12 Automatic electric ignition of oven and grill burner (depending on the models) The oven door must always be completely open, before the burner ignition To ignite the burner press the knob and turn it anticlockwise to the maximum position, for the oven burner and clockwise to the grill position for the grill burner. Keep it pressed to start up the automatic ignition of the burner. In case there is no electric current, the burner can also be lighted using a match (Fig. 13 WARNING: Do not operate the ignition for more than 15 seconds. If the burner fails to ignite, leave the oven door open for at least 1 minute before pressing the knob again. The grill must be used with the door half-open (see Fig. Fit the deflector S onto the centering pins N on the top of the oven opening (Fig. Then gently close the oven door against the deflector. Fig. 14 B 13 USE OF THE TURNSPIT TURNSPIT single For utilization of the turnspit follow the instructions described. 15), paying attention to block it within the two forks F and to balance it in order to avoid any unnecessary effort in motor R. - Put the spit on support G, after having put its opposite end into the holes P . - Place the drip tray with a little water under the spit. [. . . ] It is advisable to carry out this operation at least once a week or whenever necessary. Make sure to properly refit the burners, turning them slowly so that the burner caps engage in the injector holder seat (if perfectly centred, the burner lowers a little and locks in place). Burner cap Burner head Pan support maintenance • Clean the pan supports with a sponge and detergent whenever dirty. • The pan supports will change colour near the burners. [. . . ]