User manual WHIRLPOOL ACM920/BF

[. . . ] 400010778923. book Page 1 Thursday, March 5, 2015 4:48 PM ENGLISH IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: www. whirlpool. eu YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and always observed. This is the danger symbol, regarding safety, warning of potential risks to users and others. All safety messages will be preceded by the danger symbol and the following words: DANGER WARNING Indicates a hazardous situation which, if not avoided, will result in serious injury. Indicates a hazardous situation which, if not avoided, could cause serious injury. All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance. [. . . ] Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2 and between N1-N2). EN3 230 V 230 V 230 V 230 V 230 V 400010778923. book Page 4 Thursday, March 5, 2015 4:48 PM Connect the yellow/green earth wire to the terminal with the symbol . This wire must be longer than the other wires. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B). Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it. Secure the power cable with the cable clamp. Close the cover (C) and screw it on the terminal block with the previously removed screw. Each time the power is connected, the hob performs an automatic check for a few seconds. If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch with minimum contact gap of 3mm. INSTRUCTIONS FOR USE Control Panel Description Control panel On/Off Timer Control panel lock Power management/ Automatic function/ Ecobooster function Cooking zone controls and corresponding display On/Off Timer Control panel lock “Flexi cook models” A B Power management/ Automatic function/ Ecobooster function Cooking zone controls and corresponding display Switching the hob ON/OFF To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. All the cooking zones are deactivated If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. Switching on and adjusting cooking zones Power indicator display Selected cooking zone indication Once the hob is switched on and the pan is positioned on the chosen cooking zone, select the zone using the corresponding button: the display shows level 0. Each cooking zone has various power levels, adjustable with the +/- buttons, going from “1”: min. Some cooking zones have a fast boil function (Booster), shown on the display with the letter “P”. Cooking zone positioning Deactivation of cooking zones Select the cooking zone you wish to switch off. Press the corresponding button (a dot lights up at the bottom right of the power level indicator). Press the key “-” to set the level to “0”. To switch off instantly, hold the zone selection button for 3 seconds. The cooking zone switches off and the residual heat indicator “H” lights up. Control panel lock This function locks the controls to prevent accidental switching on of the hob. To activate the control panel lock function, switch on the hob and hold button (or the Automatic function/Eco Booster button, where present) for three seconds; an acoustic signal and a luminous indicator next to the padlock signal activation. The control panel is locked except for the deactivation function. [. . . ] • Salt, sugar and sand could scratch the glass surface. • Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s instructions). • Liquid splillages on the cooking zones may make pan vibrate or move • Dry the hob thoroughly after cleaning it. TROUBLESHOOTING GUIDE • • • • • Read and follow the instructions given in the section “Instructions for use”. Check that the electricity supply has not been shut off. [. . . ]