User manual WHIRLPOOL ACM932BF

[. . . ] Kasutusjuhised Lietošanas instrukcija Naudojimo instrukcija Instrukcja obsługi Инструкции за употреба Instrucţiuni privind siguranţa Navodila za uporabo Uputstva za upotrebu Upute za uporabu Návod k obsluze Návod na použitie Használati útmutató Инструкция по эксплуатации Пайдалану нұсқаулығы Інструкції з використання Instructions for use Bedienungsanleitung Gebruiksaanwijzing Notice d'utilisation Οδηγίες χρήσης Instruções de utilização Istruzioni per l'uso Instrucciones de uso 180 mm 240 mm 180 mm 300/180 mm 210 mm 145 mm 210 mm 145 mm 145 mm 210 mm 145 mm 180 mm 210 mm 145 mm 180 mm 180 mm 210 mm 145 mm 260 mm 210 mm 145 mm 210 mm 180 mm 145 mm 180 mm 180 mm 145 mm 180 mm 145 mm 280/180 mm 180 mm 280/180/80 mm 180 mm 300/180 mm 1 ENGLISH Installation Page 2 Instructions for use Page 4 2 A 54 mm 560 +2 mm 0 R = Min. 50 mm 580mm 650mm 700mm 510 mm 0 490 +2 mm mm 30 483 mm 553 mm 583 +2 mm 0 560+2 0 R = 11, 5 mm mm 490+2 mm 0 +1 0 513 +2 mm 0 R = 11, 5 mm 6 mm R = Min. 8 mm B 770 mm 54 mm 750 +2 mm 0 R = Min. 50 mm 510 mm 30 mm 0 490 +2 mm +1 0 483 mm 742 mm Min. [. . . ] If an undertop oven is installed, make sure the oven is equipped with a cooling system. Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them. In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112. To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance. EN6 ELECTRICAL CONNECTION Disconnect the appliance from the power supply. Installation must be carried out by qualified personnel who know the current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power cable must be long enough to allow the hob to be removed from the worktop. Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home. WARNING - - blue/grey black/brown yellow/green 1. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal. Secure the power cable with the cable clamp. To activate the control panel lock, switch the hob on and press the Lock function button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. To deactivate the control lock, repeat the activation procedure. The luminous dot goes off and the hob is active again. The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock. Timer The timer can be used to set the cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all the cooking zones. Select the cooking zone to be used with the timer, press the timer (see figure) and a beep signals the function. The display shows “00” and the LED indication comes on. The Timer value can be decreased and increased by keeping the slider function “+” and “-” buttons pressed. When the set time has elapsed, an acoustic signal EN8 sounds and the cooking zone switches off automatically. To deactivate the timer, keep the Timer button pressed for at least 3 seconds. To set the timer for another zone, repeat the above steps. [. . . ] See if you can solve the problem yourself with the help of the “Troubleshooting guide”. Switch the appliance off and then on again it to see if the problem has been eliminated. If the problem persists after the above checks, contact the nearest After-Sales Service. Always specify: • a brief description of the fault; • the product type and exact model; • the Service number (the number after the word Service on the rating plate), located under the appliance (on the metal plate). [. . . ]