User manual WHIRLPOOL ADG 165 PRODUCT FICHE

[. . . ] Press the Start button to start the selected wash programme. The Start indicator lamp will illuminate. Once set, the programmed data cannot be altered by pressing the programme selector buttons. Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. [. . . ] Note: if the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min. ). Turn the programme selector knob to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap. Upper and lower rack Lower rack A A C Rack height adjustment: Upper rack (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. • To lower: pull out the two side handles and gently lower the rack. • To raise: pull up the two side handles until the rack clicks into place. • The rack must be level on both sides. Plate holders: • (A) May be lowered to increase available space. Crockery holders: • • Down: cups and long-stemmed glasses. Marked crockery: • Is the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: with some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; this regenerates the water softening system. AFTER-SALES SERVICE If, after carrying out the above checks. the fault persists or reoccurs, switch off the appliance and close the water tap. then contact our After-Sales Service (see warranty). Please specify: • The nature of the fault. • The service code (the number indicated after the word Service on the adhesive rating plate) inside the door on the right-hand side. Important • Fill the detergent dispenser and check the salt and rinse aid level. [. . . ] wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. • Do not put liquid fat in the dishwasher (e. g. • If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. • If regeneration salt is to be added immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]