User manual WHIRLPOOL ADG 2320 FD PRODUCT FICHE

[. . . ] Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. If necessary (and if provided) the corresponding indicator lamp lights up. Select options “Change programme” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). [. . . ] until the Start indicator lamp switches off; Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON/OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks WH/II/K/GB Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. 1) depending on the model Half Load: Load the upper rack only. Place the cutlery basket (D) in the upper rack. Rack height adjustment (also when loaded): • Lower adjustment: pull out the two rack handles outwards (E) and lower the rack. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. [. . . ] • Change water hardness setting, if necessary add salt *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. [. . . ]