User manual WHIRLPOOL ADG 4820 NB PRODUCT FICHE

[. . . ] If necessary, select options (if supplied). Press the Start button to start the selected programme. Once set, the programmed data cannot be altered by pressing the programme selector buttons. Note: Once the Start button has been pressed, the dishwasher memorises the last programme selected. [. . . ] To change the selected programme, press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme using the programme selector knob and press the Start button. Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min. ). Turn the programme selector knob to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap. Upper and lower rack Upper rack Lower rack A A C Plate holders: • (A) May be lowered to increase available space. Crockery Holders: • Down: cups and long-stemmed glasses. Up: plates. • Cutlery basket: • The cutlery basket can be removed to increase (C) available space. Glass holder: C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: With some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; This regenerates the water softening system. AFTER-SALES SERVICE If, after carrying out the above checks. the fault persists or reoccurs, switch off the appliance and close the water tap. then contact our After-Sales Service (see warranty). Please specify: • the nature of the fault. • the service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • Important • • Fill the detergent dispenser and check the salt and rinse aid level. Do not use the appliance for items not suitable for washing in a dishwasher, for example. wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. [. . . ] wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]