User manual WHIRLPOOL ADG 5500/1 PROGRAM CHART

[. . . ] If the problem persists, contact the After-Sales Service. Water heating anomaly Reset and start the programme again from the beginning. If the problem persists, contact the After-Sales Service. Add rinse aid The dishwasher does not fill with water Option “Delayed start” button The wash cycle can be programmed to start after 3-6-9 hours. Press button to select the delayed start. [. . . ] All water in the tank will be drained and the programme will be stopped immediately. Turn on the water tap, close the door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. At the end of the programme a short acoustic signal will sound. The indicator lamps 4 + 5 (marked by “end” on the control panel) light up. Open the door and press the On/Off button . Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Black process 45. 0° 150. 0 LPI 39696045GB. fm Page 3 Monday, June 28, 2010 7:15 PM Dishwasher loading instructions and racks provided Upper rack: Cup holders (A): Depending on the position, up or down. Place the glasses in the middle and to the right, dishes to the left, under the cup holder grids. Place long and narrow utensils (carving forks, knives) on the bottom of the rack, not crosswise, with the sharp ends towards the appliance. depending on the model A A Rack height adjustment: Release the caps (B) of both rack rails. Reposition the rack at the desired height. The rack must be level on both sides. B B Lower rack: With tilting plate holders. Cutlery baskets: These are provided with grids (C), used to keep cutlery separated. Objects that can cause injuries must be arranged in the rack with tips facing downwards. C C C C Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Black process 45. 0° 150. 0 LPI 39696045GB. fm Page 4 Monday, June 28, 2010 7:15 PM What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. [. . . ] • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery • Use suitable glasses. • Not made of stainless steel. • Use suitable cutlery. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ]