User manual WHIRLPOOL ADG 555 IX PRODUCT FICHE

[. . . ] During this programme “St” appears on the display. Cleans the interior of your washing machine and thus helps to avoid smells or deposits. Run this programme regularly if you never or seldom wash your laundry at temperatures over 60°C or if your washing machine has not been in use for a long time. During this programme “St” appears on the display. [. . . ] €œSteam Stain Removal” button • Treats the laundry with hot steam during the wash cycle in order to help removing stains. €¢ Selectable for laundry made of cotton and/or synthetics within temperature range of 40 to 60°C. €¢ If you select this option, “St” appears on the display during the steam phase. €œDOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in your Instructions for Use. “Clean pump” Waste water is not pumped out. The indication lamp of the predefined spin speed lights up; in case you want to set another spin speed, press the “Variable spin” button. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. unsuitable combinations of options are deselected automatically. €œPrewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. €¢ Do not use liquid detergent for the main wash when activating the Prewash option. €œRinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics” , “Daily load” and “Delicates”. €¢ It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. €¢ If you select “Rinse hold”, do not leave the laundry to soak for too long. [. . . ] Select the new programme, temperature, any options and another spin speed if you want. press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. [. . . ]