User manual WHIRLPOOL ADG 6230 IX INSTRUCTION FOR USE

[. . . ] The corresponding indicator lamp switches on. Once set, the programmed data cannot be altered by pressing the programme selector button. Note: Once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply. [. . . ] Select a new programme using the programme selector knob and press the Start button. Note: If the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of a programme, an acoustic signal is activated 4 times, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for approx. Only open the door once the wash cycle has terminated (caution: danger of scalding from steam) and press the OFF button to switch the dishwasher off. Unload the lower rack before the upper one. Close the water tap. Upper and lower rack Crockery Holders: Lower rack Upper rack • • Down: cups and long-stemmed glasses. Up: plates. C Cutlery basket (C): • • With or without handle (depending on model). The cutlery basket can be removed to increase available space. C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. • Is the salt container cap (water softening system) screwed down?Marked crockery: • Has the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: With some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; This regenerates the water softening system. • AFTER-SALES SERVICE If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • Important • • Fill the detergent dispenser and check the salt and rinse aid level. [. . . ] Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]