User manual WHIRLPOOL ADG 6245 FD PRODUCT FICHE

[. . . ] When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks. To resume the cycle push the Start button and close the door within 3 seconds. CANCEL/OFF BUTTON Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute. If pressed when the dishwasher is switched off it drains any possible liquids from dishwasher (1 minute process). [. . . ] - Press the START button and close the door within 3 seconds (the program resumes the cycle from where it was interrupted). To Cancel the program on running: - Open the door, press the CANCEL/ Off button and close the door. - (Water drains for up to 1 minute then the appliance switches off). To change the program in progress: - Open the door, press the CANCEL/Off button to cancel the running program and close the door. - (Water drains for up to 1 minute then the appliance switches off). - Open the door and press any button except CANCEL/Off button to switch on the appliance. - Press the START button and close the door within 3 seconds Switching off the appliance. Everything OK. . . After the program is completed appliance turns into Standby mode automatically. Exercise caution when opening the door: beware of hot steam. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to dissipate, helping the dishes to dry. . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry Water too hard. - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “Delayed start” option). Try releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid (see page 3, “Adding rinse aid”). [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]