User manual WHIRLPOOL ADG 6340/2 IX INSTRUCTION FOR USE

[. . . ] Detailed instructions are given in chapter “What to do if. . . ”. HALF LOAD The half load cycle can be used for the upper or lower rack. Select the required program then press the “Half load” button. The light comes on and goes off at the end of the programe. This function can be used with the programs marked with the relative description in table. Table of programs P 1 Programs Available options Consumption Detergent Litres kWh Minutes 1) Loading instructions Pre-Wash cold — Crockery to be washed later. [. . . ] Clean spray nozzles under running water (use toothpicks if necessary) . . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. . . . is not working/will not start . . . shows “F1” on the display or the START indicator lamp flashes once . . . shows “F4” on the display or the START indicator lamp flashes 4 times . . . shows “F6” on the display or the START indicator lamp flashes 6 times . . . shows “F7” on the display or the START indicator lamp flashes 7 times . . . shows “F8” on the display or the START indicator lamp flashes 8 times Possible causes. . . “Delayed start” option is ON. The water supply temperature is below 3°C. Kinked water inlet hose or clogged inlet filters. Kinked water inlet hose or clogged inlet filters. Too little water in the dishwasher’s water system. - Check the household circuit fuse if there is no power supply. - Check if the dishwasher’s door is closed. - Check whether the “Delayed start” option (if available) has been selected. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “delayed start” option). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid - see page 3, “Adding rinse aid”. - The rapid program is intended for quickly washing lightly soiled dishes. If used for a full load of medium/heavy soiled dishes, the dishes may not dry completely. [. . . ] - The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. [. . . ]