User manual WHIRLPOOL ADG 6340/2 NB INSTRUCTION FOR USE

[. . . ] Normally or heavily soiled crockery with dried-on food. X X X X 5. 0 13. 0 12. 5 16. 0 (4. 2) (13. 0) (10. 5) (14. 5) Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage etc. Reference programme for Test Institute and energy-label. 5019 100 91206 (We reserve the right to make technical modifications) How to use the dishwasher 1. After loading the dishwasher, close the door properly and open the water supply tap. The dishwasher switches on automatically as soon as the programme selector knob is turned. [. . . ] Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply. To change the selected programme, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme using the programme selector knob and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min. ). Turn the programme selector knob clockwise to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. (The use of poor quality detergents may result in less effective washing). • Are the filters clogged or incorrectly assembled?(See “Care and Maintenance” chapter in the user instructions). • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted?• Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?(See “Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). [. . . ] • Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. • Do not put liquid fat in the dishwasher (e. g. • If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. • If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]