User manual WHIRLPOOL ADG 6448 NB PRODUCT FICHE

[. . . ] After a pre-wash of the dishes the previously set wash is started. To quit selection and start the wash program without the delayed start, press button (D) until the 3-6-9 indicator lamps go off. Water heating anomaly Reset and start the programme again from the beginning. If the problem persists, contact the After-Sales Service. The dishwasher does not fill with water Check the water supply and filters, and make sure that there are no kinks in the water inlet hose. Open and close the door in order to continue. The dishwasher does not drain Make sure that the filter unit and drain hose are not clogged and if necessary clean them. Flow meter (if provided) anomaly Reset and start the programme again from the beginning. [. . . ] The lamp will light up when the function is activated. If the temperature is not maintained during the antibacterial cycle (e. g. if the door is opened or a power failure occurs), the lamps will start blinking to indicate that the antibacterial action is not guaranteed. Alternate washing system (if provided) anomaly Reset and start the programme again from the beginning. If the problem persists, contact the After-Sales Service. Fault in water load system Switch off the dishwasher and contact the After-Sales Service. Programme chart Programmes Loading Instructions Detergent 2) A X X X X Consumption 3) Litres 6. 0 13. 0 17. 0 17. 0 20. 0 B X X kWh 0. 03 1. 00 1. 05 1. 28 1. 45 Minutes 16 60 150 90 110 Pre-Rinse Rapid 30’ Bio/Eco 1) Normal Intensive 1) 2) cold Crockery to be washed later. 45°C Lightly soiled crockery with no dried-on food. 65°C Normally or heavily soiled crockery. 70°C Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans. 3) Reference programme for energy label in compliance with EN 50242 regulations; Refer to “User instructions“; Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc. Whirlpool is a registered trademark of Whirlpool USA 5019 396 96027 (We reserve the right to make technical modifications) Black process 45. 0° 150. 0 LPI 3GB96027. fm Page 2 Thursday, September 16, 2004 2:58 PM How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door Press the On/Off button . Large compartment A C A B How to fill the detergent dispenser Small compartment B Check the rinse aid level Mechanical indicator lamp C. Electric indicator on control panel (if provided). On models with water softener system only. • Open the tap. Remedy • Clean the water supply tap filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug into the mains socket. Check the domestic circuit fuse. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. • Increase dosage *. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly clean • The water jet does not reach the crockery. [. . . ] • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean them*. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Reduce the rinse aid dosage *. [. . . ]