User manual WHIRLPOOL ADG 655

[. . . ] Quick reference guide BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE GUARANTEE IS NOT APPLICABLE IF FAULTS ARE CAUSED BY INCORRECT USE OF THE APPLIANCE. Chart PROGRAMME SELECTOR KNOB (see "Table of programmes" below). START BUTTON The indicator lights up during operation, flashes when a fault occurs, and goes off at the end of the programme. START BUTTON RESET FUNCTION: Press this button for at least 2 seconds; the selected programme and options will be cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. [. . . ] If necessary, set the delayed start to "0" (RESET the appliance). - Check that the water supply temperature is above 3°C. - The closure disk of the syphon hose connection must be removed. - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be clogged. - The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty. - The filters must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry . . . have discoloured plastic parts . . . opaque glasses, etc . . . removable deposits on glasses . . . glasses not sparkling . . . permanent deposits on glasses Tomato/Carrot juice. Dishes unsuitable for washing in dishwashers (porcelain), Usage of incorrect programmes for glasses. Not conform of glasses to washing in dishwashers (porcelain). - Set "Detergent type" option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2 "How to set water hardness"). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using "delayed start" option). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. [. . . ] Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. We reserve the right to make technical modifications. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician. [. . . ]