User manual WHIRLPOOL ADG 655 NB PROGRAM CHART

[. . . ] If the problem persists, contact the After-Sales Service. To set the water hardness level, follow the instructions in the enclosed handbook. The wash cycle can be programmed to start after 1-9 hours. The delayed start can be programmed either before or after selecting the desired wash programme. When the door is closed, a prewash cycle is run, after which the delayed start countdown begins. Reset and start the programme again from the beginning. [. . . ] If the problem persists, contact the After-Sales Service. Fault in water load system Detergent 2) Switch off the dishwasher and contact the After-sales Service. Programme table Programmes Loading instructions Consumption 3) Litres kWh Minutes A B Prewash Rapid Plus Eco Normal Intensive + + + (*) 1) 2) cold Dishes to be washed later. X X X X X X X X - 6. 0 13. 0 17. 0 17. 0 24. 0 20. 0 17. 0 14. 0 0. 03 0. 85 1. 05 1. 28 1. 75 1. 20 1. 08 1. 25 16 45 140 100 115 80 180 95 45°C Light dirt, e. g. 70°C very dirty dishes, particularly Recommended programme for recommended for pots and pans. Delicate Bio 1) Daily 45°C Light dirt with no dried-on food. 65°C Normal dirt or very dirty. 3) Extra functions available in all programmes, except prewash. Reference programme for energy label in compliance with Standard EN 50242 (top basket adjusted in top position); Refer to “User instructions”; Programme data obtained in conformity with European standard EN 50242. The data may vary according to, for example, different loads, water temperatures - above or below 15° C - or water hardness and different power supply voltage, etc. Whirlpool is a registered trademark of Whirlpool USA 5019 396 96037 (We reserve the right to make technical modifications) Black process 45. 0° 150. 0 LPI 39696037GB. fm Page 2 Monday, February 20, 2006 12:37 PM How to use the appliance For further indications refer to the individual sections of the user instructions. Open the door Press the On/Off button. Large compartment A. C A B How to fill the detergent dispenser Small compartment B. Check the rinse aid Mechanical indicator C. Electric indicator on control panel (if provided). On models with water softener system only. Electric indicator on control panel (if provided). Refer to the dishwasher loading instructions. button until the indicator of the required programme D Check the regeneration salt Load the racks Select a programme Select extra functions If necessary (and if provided). • Clean the water cock inlet filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug in the power socket. Check the house fuse. If the dishes are not perfectly dry • Insufficient rinse aid. • Residual water in cavities. • Increase dosage *. • Arrange dishes so that they do not touch. • Follow recommended detergent dosage. • Select a more intensive wash programme. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. [. . . ] • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. • Check filters regularly/if necessary clean them *. • Refit and secure the filters, making sure they are inserted correctly *. [. . . ]