User manual WHIRLPOOL ADG 687 FD WP PROGRAM CHART

[. . . ] Start the dishwasher again by pressing the Start button. Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. At the end of the programme an acoustic signal will sound and “End” will appear on the display. Once the Start button has switched off: press OFF, all the indicator lights will switch off. [. . . ] Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • Removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. (if provided). • Use suitable glasses. • Use suitable cutlery. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! ADG 687 Quick Reference Guide Options 3) Time and failure display GB On button Off button Programme selection button The selected programme is shown in the window of the display. Switches “on” when the dishwasher is operating. [. . . ] Light soiling, for example glasses and cups. Lightly soiled crockery with no dried-on food. Normally soiled crockery. X X 13. 0-20. 0 1. 10-2. 00 100-150 cold 40°C 40°C 50°C - - 4. 0 0. 03 14 X - 10. 0 0. 85 100 X - 10. 0 0. 65 30 X X 13. 0 1. 05 195 Reference programme for energy label EN 50242; 4) The bacteria removal efficiency has been tested by the Refer to “User instructions”; Institut Pasteur de Lille (France), based on the NF The data relevant to programmes are values obtained in the EN 13697 standard of November 2001. laboratory in conformity with Standard EN 50242. [. . . ]