User manual WHIRLPOOL ADG 6915 IX INSTRUCTION FOR USE

[. . . ] Values may vary in relation to usage, rinse option. e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. Whirlpool is a registered trademark of Whirlpool USA (We reserve the right to make technical modifications) WH/I/B/GB 5019 396 91502 How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Press the ON / OFF button. Compartment A: Fill the detergent dispenser With each wash cycle. [. . . ] Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. The corresponding indicator lamp lights up. “Change programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. [. . . ] • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • Removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. [. . . ]