User manual WHIRLPOOL ADG 6967 ALU PROGRAM CHART

[. . . ] Press once = upper rack (the indicator lamp comes on) Press twice = lower rack (the indicator lamp comes on) Press 3 times = Off (half load function deactivated). Time and failure display 3) Indicates in hours the time remaining until the start of the wash cycle. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes. “F. . . ” Identification of faults for service technician Wash cycle “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours. [. . . ] Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. depending on the model Half Load: Load the upper rack only. Place the cutlery basket (D) in the upper rack. Rack height adjustment (also when loaded): • Lower adjustment: pull out the two rack handles outwards (E) and lower the rack. • Upper adjustment: pull the two handles (E) upwards until the rack clicks into place (Factory setting). The rack must be level on both sides. Lower rack: Depending on the model with fixed or tilting plate holders (F). Half Load: Load the lower rack only. Greater washing power, particularly for plates and saucepans. Cutlery basket (G) or (H): Some models are provided with a grid (I) that can be fitted onto the cutlery basket to keep items separated. Cutlery basket (D) for appliances with half load only. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the handles positioned upwards. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Spare parts which are sold separately: 1) Multi-purpose support (A) - N. WGH 1000 series. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • • • • • • • Remedy • Starting the selected programme. Clean the water supply tap filter. Ensure there are no kinks in the water hose. The programme can be set to “0” to start. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. [. . . ] Select a new programme and press the Start button again. • Call the After-Sales Service. • Indicator F. . . (if provided). If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ]