User manual WHIRLPOOL ADG 7441 IX PRODUCT FICHE

[. . . ] Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: Switch on the appliance How to fill the detergent dispenser With each wash cycle. Small compartment B: For programmes with pre-wash only. A B C Check the rinse aid level Mechanical indicator C. Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. [. . . ] Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select options If necessary (and if provided) the corresponding indicator lamp lights up. Press the Start button The selected programme is then memorised (even in the event of power failure). “Change programme” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Wash cycle Switch off the appliance Turn off the water tap, unload the racks Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob). Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. WH/II/K/GB Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. [. . . ] • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. [. . . ]