User manual WHIRLPOOL ADG 7542 NB PROGRAM CHART

[. . . ] 8 Before using the dishwasher, read the installation and maintenance instructions carefully!OVERVIEW Programme selection button Press the button (repeatedly) until the indicator lamp of the desired programme lights up (see table 1. At the end of the wash cycle, the last programme selected is memorized. Half load/Multizone Load the upper or lower rack only. [. . . ] To flip towards the centre of the rack, turn and fix in the rack. Folded away flipped up Long utensils (kitchen knives) must be arranged with the sharp end facing the inside of the appliance. A Cutlery basket B When selecting the “Half load/Multizone” function, position one of the cutlery baskets E in the upper rack without the grid element F. Rack height adjustment C The upper rack height can be changed even when loaded Lower adjustment: pull the two handles C out and lower the basket. Upper adjustment: pull the two handles C upwards until the rack clicks into place (standard position). C B C D The two handles C must be level. Washing without the upper rack If the appliance is equipped with the adjustable retainers shown, the upper rack can be removed for washing large plates, trays etc. Open the two retainers D and remove the rack from the runners, pulling towards you. When the upper rack is in place the retainers must always be closed. Retainer closed D Retainer open D LOWER RACK - depending on model: Cutlery E With removable grid element F for keeping items of cutlery separate for optimum wash baskets results. Plate holders G Fixed or flip-up (space-saving for pots and pans) Side support H With flip-up support for long cutlery, cups, etc. Fully detachable: to remove, pull (if present) towards the front of the rack. Power Clean I On selecting this option, an intensive wash cycle is run using the special nozzles at the rear of the dishwasher. Turn the plate holder in the sector as marked. Position the pots with the insides facing the nozzles. G H E Sharp utensils that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Arrange crockery to that water does not collect in cavities and the spray arms can turn freely. Do not use the dishwasher for washing wooden items, aluminium, tin, silver cutlery or decorated crockery (unglazed). SELECT PROGRAMME Press the Programme Selection button until the required programme appears (Table 1. These are saved at the end of the cycle even if another programme is selected. The corresponding indicator lamp lights up. WASH CYCLE The dishwasher door must be closed and the water tap open. [. . . ] Have deposits: - regeneration salt residue - rust marks In the event of frequent use of low temperature programmes (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”). The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. In areas with very hard water, more regeneration salt needs to be added (see page 4, “How to check/fill/adjust salt”). If you use a combined action detergent which includes salt, do not add any additional regeneration salt. [. . . ]