User manual WHIRLPOOL ADG 7561 INSTRUCTION FOR USE

[. . . ] The corresponding indicator lamp lights up. If required, select options (if supplied). Press the Start button to start the selected programme. Once set, the programmed data cannot be altered by turning the programme selector knob. [. . . ] The Start indicator lamp will switch off. Select a new programme using the programme selector knob and press the Start button. Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) switches on (for about 30 min. ). Once the Start indicator lamp has switched off, turn the programme selector knob to “0” to switch the dishwasher off. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. • • • • Upper and lower rack To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack Crockery holders: A A Upper rack C “Flex 3”: multi-purpose support • Half load / Multizone: Loading the lower rack only gives greater washing power, especially for plates and saucepans. B • Half Load / Multizone: If only the upper rack is to be loaded, place the cutlery basket (B) in the upper rack. 3. To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. Please specify: • The nature of the fault. • The service code (the number after the word Service on the adhesive rating plate) inside the door on the right-hand side. • • • • • • • • Important • • Fill the detergent dispenser and check the salt and rinse aid level. Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). Sometimes even after the regeneration salt container has been filled, the corresponding indicator lamp (if present) may light up during the first wash cycle. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities?If so, close the water supply tap, detach the water hose and clean the filter. [. . . ] Start the programme again from the beginning: Press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button. • • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted? [. . . ]