User manual WHIRLPOOL ADG 789 U PROGRAM CHART

[. . . ] Check the salt and rinse aid level indicators before you start the machine. Use the programme selection button to choose your washing programme. - When there are few dishes, additionally use the Half load button. Start the programme with the start / stop button: Close the door then programme starts. Attention Avoid opening the door during the washing process. [. . . ] Stop the programme with the start / stop button if you would like to open the door once the dishwasher’s washing programme is running. Half Load (1/2) button When there are few dishes, you press this button after pressing the programme selection button. When turning the dishwasher on, the indicator light on the button lights up. This function helps you to save water and energy. Display Water hardness level and Time Delay for the selected programme are displayed. Time Delay This option enables you to start the selected programme with a delay of 1 – 24 hours. Time Delay is adjusted by pressing plus delay button near the display. After adjusting the required Time Delay, press Start / Stop button and close the door. At the end of the delay set, the programme starts automatically. During a programme, Time Delay option does not function. Programme selection buttons Use the programme selection button to select the desired programme. The corresponding programme light lights up. How to cancel the washing programme To cancel a programme while the machine is operating: Press start/stop button. Press start/stop button for 5 seconds again. The indicator light will start flashing. The machine will drain the water inside the machine for 45 seconds. The programme is cancelled when start/stop indicator light goes off. Then, you can choose and start a new programme. [. . . ] When the colour is light, open the container and add dishwasher salt. Empty GB Control indicator lights 2 Rinse aid level indicator light 2 If this indicator light comes on, you have to refill rinse aid. You can also tell whether rinse aid must be refilled by looking at the rinse aid dispenser. When the visual fill indicator is dark, there is enough rinse aid in the dispenser. When the colour is light, open the dispenser and refill rinse aid. 3 3 Salt level indicator light 2 3 SALZ S EL TU Z Full S EL Note for Testing Institutes The necessary information for performance testing will be provided upon request. [. . . ]