User manual WHIRLPOOL ADG 799 PRODUCT FICHE

[. . . ] • Items not suitable for dishwashing ……………………………………………………. Installing the machine ………………………………………………………………………. • Positioning the machine ………………………………………………………………. . . • Water connections …………………. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . • Water inlet hose …. ……………………………………………………………………… • Water outlet hose …. . ………………. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Otherwise, white lime residues will remain on the dishes and the interior equipment. This will negatively affect your machine’s washing, drying and shining performance. When water flows through the softener system, the ions forming the hardness are removed from the water and the water reaches the softness required to obtain the best washing result. Depending on the level of hardness of the inflowing water, these ions that harden the water accumulate rapidly inside the softener system. Therefore, the softener system has to be refreshed so that it operates with the same performance also during the next wash. For this purpose, dishwasher salt is used. Filling with salt Use softener salt specifically produced for use in dishwashers. To put softener salt, first remove the lower basket and then open the salt compartment cap by turning it counter clockwise. 1 2 At first fill the compartment with 2kg salt and water3 at overflowing level If available, using the funnel 4provided will make filling easier. refit the cap and close it. If the salt warning lamp on the control panel becomes on fill the salt SALT compartment with salt again. Fill the salt compartment with water at first use only. If you put a tablet into the salt compartment, do not fill the compartment completely. Do not fill detergent into the detergent compartment more than required; otherwise it may cause scratches on your glasses as well as lead to a poorly dissolved detergent. Should you need more information concerning the detergent you will use, contact detergent manufacturers directly. Filling the detergent compartment Push the latch to open the detergent container as shown in the image. It is possible to measure the right detergent amount using these lines. 3 Detergent pod can take totally 40 cm detergent. Open the dishwasher detergent and pour into the larger 3 compartment a 25 cm if your dishes are heavily soiled or 15 3 cm if they are less soiled. 2 If your dishes have been kept dirty for a very long time, if there are dried food wastes on them, and if you have overly loaded the 3 dishwasher, pour a 5cm detergent into the pre-wash compartment and start your machine. You may have to add more detergent into your machine, depending on the degree of soil and on the water hardness level in your area. Combined detergents Detergent manufacturers also manufacture combined detergents that are called 2 in 1 – 3 in 1- 5 in 1. . . The 2 in1 detergents contain detergent+ salt or rinse aid . While using the 2 in 1 detergents, it should be observed which functions the tablet consists of. The other tablet detergents also have detergent+rinse aid +salt+various extra functions. [. . . ] • 23 • • • Filters clogged. Water drain pump clogged. If there are white looking stains on the dishes • A very small amount of detergent is being used. • Rinse aid dosage setting at a very low level. • No special salt is being used despite the high degree of water hardness. [. . . ]