User manual WHIRLPOOL ADG 8452 IX PROGRAM CHART

[. . . ] 70°C heavily soiled crockery, especially suitable for pans and saucepans. 3) Recommended programme for Reference programme for energy label in compliance with EN 50242 regulations; Refer to “User instructions“; Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. Whirlpool is a registered trademark of Whirlpool USA 5019 396 91167 (We reserve the right to make technical modifications) WH/I/K/GB How to use the appliance Further indications are given in the single chapters and in the user instructions. Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: Switch on the appliance How to fill the detergent With each wash cycle. Small compartment B: For programmes with pre-wash only. A B C Check the rinse aid level Mechanical indicator lamp C. [. . . ] Place the cutlery basket (D) in the upper rack. Rack height adjustment (also when loaded): • Lower adjustment: pull out the two rack handles outwards (E) and lower the rack. • Upper adjustment: pull the two handles (E) upwards until the rack clicks into place (Factory setting). The rack must be level on both sides. Lower rack: Depending on the model with fixed or tilting plate holders (F). Half Load: Load the lower rack only. Greater washing power, particularly for plates and saucepans. Cutlery basket (G) or (H): Some models are provided with a grid (I) that can be fitted onto the cutlery basket to keep items separated. Cutlery basket (D) for appliances with half load only. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the handles positioned upwards. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Spare parts which are sold separately: 1) Multi-purpose support (A) - N. WGH 1000 series. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • • • • • • • Remedy • Starting the selected programme. Clean the water supply tap filter. Ensure there are no kinks in the water hose. The programme can be set to “0” to start. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • The water jet does not reach the crockery. • Spray arms blocked. • Increase dosage *. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Spray arm nozzles clogged. [. . . ] Press the Start button for 2 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button again. • Call the After-Sales Service. • Indicator F. . . (if provided). If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ]