User manual WHIRLPOOL ADG 853 PT WP PROGRAM CHART

[. . . ] Normally soiled bed linen, table linen and underwear, towels, shirts etc. Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. [. . . ] Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA. 5019 312 00041 CONSUMPTION DATA Temperature Selector Programme Cotton Cotton Cotton Synthetic Synthetic Delicate Wool Silk (°C) 90 60 40 60 40 40 40 30 (kg) 5. 0 5. 0 5. 0 2. 0 2. 0 1. 5 1. 0 1. 0 (l) *63 55 55 56 50 60 60 60 (kWh) 1. 80 0. 95 0. 55 0. 80 0. 40 0. 55 0. 50 0. 30 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:35 1:30 0:50 0:40 0:50 Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. PREPARATION OF WASH CYCLE 1. Load the machine, close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. The pilot lamp of the “On/Off“ button, a spin speed indicator lamp and, in case of availability, a temperature indicator lamp light up. Turn the programme selector knob to the desired programme and temperature. The knob will move half a step for correct positioning. The temperature indication (if available) switches to the selected temperature. “Cold Wash” button • Can be used with all washing programmes. “Half Load” button • Can be used for small loads and lightly soiled laundry. • Reduces the water consumption especially during the rinses. “Intensive Rinse” button • One rinse cycle is added to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading. • This option is particularly recommended for the “Synthetic” or “Delicate” programmes. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. [. . . ] Open the door and the drum flaps and unload the machine. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Turn the programme selector knob to the new programme. The programme selector knob moves half a step and the pilot lamp of the “Start” button flashes. If necessary, select the additional options and the spin speed. [. . . ]