User manual WHIRLPOOL ADG 8531 FD WP PROGRAM CHART

[. . . ] Electric indicator on control panel (if provided). Select, save, and supply the detergent Check the rinse aid level Check the regeneration salt level Load the racks Select a programme Refer to the dishwasher loading instructions. The display shows the last programme selected. Press P or until the selected programme lights up. Select additional options If necessary the corresponding indicator lights up. “Change programme in progress” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. [. . . ] The rack must be level on both sides. Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (F) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. Retainer closed Retainer open F F Lower rack: Depending on the model with fixed or tilting plate holders (G). Half Load: Load the lower rack (see description of Options). Greater washing power, particularly for plates and saucepans. Cutlery basket (J) or (H): Some models are provided with a grid (I) that can be fitted onto the cutlery basket to keep items separated. Cutlery basket (D), if provided, for appliances with half load only. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Spare parts which are sold separately: 1) Multi-purpose support (A) - N. WGH 1000 series. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • Open the tap. Remedy • Clean the water supply tap filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug into the mains socket. Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. [. . . ] Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! ADG 8531 Quick Reference Guide GB On button Options 3) “Delayed start” button The wash cycle can be programmed to start after 3-6-9 hours. The wash programme will start at the set time. Off button Programme selection button Start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. Indicators Add rinse aid Add regeneration salt Only add regeneration salt immediately before starting a wash programme. Programme chart Programmes Loading instructions Detergent 2) A X Consumption 3) Litres kWh Minutes B - Quickwash Eco 1) 4) Daily Intensive Half Load 1) 2) 40°C 50°C 60°C 70°C 50°C Lightly soiled crockery with no dried-on food. Normally soiled crockery. 13. 0 0. 70 30 X X 16. 0 1. 05 195 Normally or heavily soiled crockery. [. . . ]