User manual WHIRLPOOL ADG 8532/2 IX PROGRAM CHART

[. . . ] Electric indicator on control panel (if provided). Select, save, and supply the detergent Check the rinse aid level Check the regeneration salt level Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up. The corresponding indicator lamp lights up. [. . . ] When the upper rack is in place the retainers must always be closed. Retainer closed Retainer open F F Lower rack: Depending on the model with fixed or tilting plate holders (G). Half Load: Load the lower rack (see description of Options). Greater washing power, particularly for plates and saucepans. Cutlery basket (J) or (H): Some models are provided with a grid (I) that can be fitted onto the cutlery basket to keep items separated. Cutlery basket (D), if provided, for appliances with half load only. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Spare parts which are sold separately: 1) Multi-purpose support (A) - N. WGH 1000 series. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • Open the tap. Remedy • Clean the water supply tap filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug into the mains socket. Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. [. . . ] Switches off at the end of the programme. “Half load” button Indicators Add regeneration salt Only add regeneration salt immediately before starting a wash programme. The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme. The “Half Load” function can be used with programmes marked with an *. Add rinse aid Programme chart Programmes Loading instructions Detergent 2) Consumption 3) Litres kWh Minutes A X X X X B X X X Pre-Rinse Rapid 30 min Eco 1) 4) (*) Normal (*) Intensive 1) 2) cold Crockery to be washed later. [. . . ]