User manual WHIRLPOOL ADG 8720 IX PRODUCT FICHE

[. . . ] This interrupts the washing process, and hot steam will escape. When the door is closed, the programme will continue. An audio signal with an interval of 10 seconds warns you to switch your machine off when the selected washing program ends. [. . . ] This audio signal warns you for a duration of 5 minutes and then turns off. Open the door Press the on/off button after the programme is completed. Allow your dishes to cool for 15 minutes, with the door open. Begin with the lower basket. PROGRAMME TABLE Programme number 1 2 3 Reference ** 4 5 Programme name Pre-wash Cleaning temperature 30 Min. Eco Normal Intensive Used dishes which are to be washed at a later time 35°C Dessert and coffee dishes with food leftovers which are not dried on 50°C Normally dirty dishes with starch containing food leftovers which are not dried on 60°C Normally dirty dishes with food leftovers which are not dried on 70°C Especially dirty dishes with food leftovers which are dried on Suited to Degree of dirtiness Detergents 15 cm³ 15-25 cm³ + 5 cm³ - Few medium medium High Pre-wash End x 35°C wash Cold rinse Cold rinse Cold rinse End x x Pre-wash x x Pre-wash x x 50°C Pre-wash 70° wash Cold rinse Cold rinse Dry End 50° wash Clear rinse Clear rinse Dry End 60°wash Clear rinse Clear rinse Dry End Programme process Duration (min) Energy (kWh) Water (I) 15 3, 6 30 0, 75 10, 2 140 0, 95 13 96 1, 02 13, 2 110 1, 32 15, 2 The consumption values shown in the table were determined under standard conditions. For this reason, deviations are possible under practical conditions. ** Reference programme für test institutes The tests in accordance with EN 50242 must be carried out with a full salt container of the water softener, a full reservoir for the rinse aid and the testing programme. Load capacity : 9 FUNCTION BUTTONS Function buttons On/off button You turn your dishwasher on / off with this button. Make sure the items in the dishwasher are not used before washing properly. How to change the washing programme To change the programme selection while the machine is operating open the door. The indicator light will be on and close the door new programme will start. Important: The new programme will NOT start right from the beginning. It will start from the stage last carried out by the previous programme selection. Attention - Depending on the length of the terminated programme - detergent and rinse aid may still be in the dispensers. GB Control indicator lights 2 Rinse aid level indicator light 2 If this indicator light comes on, you have to refill rinse aid. You can also tell whether rinse aid must be refilled by looking at the rinse aid dispenser. [. . . ] You can also tell whether rinse aid must be refilled by looking at the rinse aid dispenser. When the visual fill indicator is dark, there is enough rinse aid in the dispenser. When the colour is light, open the dispenser and refill rinse aid. 3 3 Salt level indicator light 2 When this indicator light comes on, you must refill special salt. [. . . ]