User manual WHIRLPOOL ADG 8798 A PC FD INSTRUCTION FOR USE

[. . . ] Water connection 5019 106 01273 Connection to the mains water supply must be carried out by a qualified technician in compliance with the manufacturer's instructions and applicable local safety regulations. All local water board regulations must be complied with. The inlet hose must be securely clamped to the water tap to prevent leaks. [. . . ] Do not cut hoses and, in the case of appliances fitted with a waterstop system, do not immerse the plastic casing containing the inlet hose in water. Before using the appliance for the first time, check the water inlet and drain hose for leaks. Electrical Connection All local electricity board regulations must be complied with. Voltage information is shown on the rating plate mounted inside the door on the right hand side. The appliance must be earthed as prescribed by law. Do not use extension leads or multiple adapters. If the power cable is damaged, replace it with an identical one. The power cable must only be replaced by a qualified technician. After appliance installation, the mains plug must be easily accessible so that the appliance can be unplugged if necessary at any time. For Austria: If a fault current switch is fitted upline of the appliance, this must be pulse current-sensitive. Assembly instruction During assembly the appliance must be unplugged from the mains. Set any electrical screwdrivers to a low torque. Leave a gap of at least 3 mm between the top edge of the wooden door and the worktop. Do not seal the gaps between adjacent units and the worktop (for example with silicone). Attention: When transporting and assembling the appliance, always wear gloves to protect fingers / hands from sharp edges and corners. If the appliance is installed at the end of a row of units, making the side panel accessible, the hinge area must be covered to prevent any risk of crushing (cover available from After-sales Service ). Be careful with uneven installation surfaces: Carefully push the dishwasher with feet unscrewed under the worktop. [. . . ] Do not use abrasive products or alcohol on the control panels. All sizes in this assembly instruction are given in millimetres. Packaging varies according to the dishwasher model. 4. [. . . ]