User manual WHIRLPOOL ADG 931 IN INSTRUCTION FOR USE

[. . . ] • Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations • Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers. • On completion of the wash programme switch off the dishwasher and turn off the water tap. • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. [. . . ] Fill the dispenser with rinse aid while monitoring the level indicator D (about 130 ml). Immediately wipe away any spilt rinse aid to prevent excess suds which may spoil washing results. Visual indicator: light = empty dark = full. How to adjust the rinse aid dosage regulator. (Open the cover and close again following adjustment). If you are not satisfied with washing or drying results, change the dial setting with a spoon handle or coin (see E in the drawing). If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, dull or spotted, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. Always use the recommended dosage stated on the detergent pack. The use of detergent in excess of the recommended dosage may cause suds, poor washing results and pollution. The recommended dosage varies between different brands. Only fill the detergent dispenser prior to start a wash programme. To open on lid (see C in the drawing). 55 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks. • When installing the appliance, make sure the drain water discharges correctly and, if necessary, remove the wire gauze from the sink siphon. • Secure the drain hose with a clamp to the siphon to prevent it from dropping off during operation. • For appliances with water-stop system only: if the water connections are made correctly, the water-stop system safeguards your home against damage caused by flooding. Electrical connections: • Closely adhere to local Electricity Board regulations. [. . . ] • Remount the spray arm by aligning it with the rotor pin and insert it. • Remount the spray arm and pull it down. Rotate the central filter H by turning it counter-clockwise and extract it by pulling it up. Pull out the cylindrical filter L and extract it from the microfilter M separate the plactic filters by gently pushing on both pieces and pull (see drawing). [. . . ]