User manual WHIRLPOOL ADG 9415/1 PROGRAM CHART

[. . . ] Electric indicator on control panel (if provided). How to fill the detergent dispenser A BC Check the rinse aid level Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Refer to the dishwasher loading instructions. The display shows the last programme selected. [. . . ] • Upper adjustment: pull the two handles (E) upwards until the rack clicks into place (Factory setting). The rack must be level on both sides. Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (F) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. Retainer closed Retainer open F F Lower rack: Depending on the model with fixed or tilting plate holders (G). Half Load: Load the lower rack (see description of Options). Greater washing power, particularly for plates and saucepans. Cutlery basket (J) or (H): Some models are provided with a grid (I) that can be fitted onto the cutlery basket to keep items separated. Cutlery basket (D), if provided, for appliances with half load only. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Spare parts which are sold separately: 1) Multi-purpose support (A) - N. WGH 1000 series. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • The appliance does not load sufficient water. • Open the tap. Remedy • Clean the water supply tap filter. • Ensure there are no kinks in the water hose. • • • • Insert the plug into the mains socket. Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. [. . . ] Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! ADG 9415 Quick Reference Guide GB On button Off button Programme selection button Start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. Indicators Add regeneration salt Only add regeneration salt immediately before starting a wash programme. Programme chart Programmes Loading instructions Detergent 2) A B Consumption 3) Litres kWh Minutes Pre-Rinse cold Crockery to be washed later. - - 5. 0 0. 02 10 Quickwash 40°C Lightly soiled crockery with no dried-on food. X - 13. 0 0. 70 30 Eco 1) 4) 50°C Normally soiled crockery. X X 16. 0 1. 05 195 Intensive 1) 2) 70°C Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans. 3) X X 17. 0 1. 65 145 Reference programme for energy label EN 50242; Refer to “User instructions”; 4) Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. Whirlpool is a registered trademark of Whirlpool USA The data relevant to programmes are values obtained in the laboratory in conformity with Standard EN 50242. [. . . ]