User manual WHIRLPOOL ADG 9442 WH PRODUCT FICHE

[. . . ] After loading the dishwasher, turn on the water supply tap and open the dishwasher door. Press the On button to switch the dishwasher on. One of the programme indicator lamps will light up. Press the programme selector button until the corresponding indicator lamp switches on. [. . . ] This information remains in the memory even during interruption of the power supply. To change the selected programme, open the door (caution: danger of scalding from steam!) and press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button again. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. 5 To indicate the end of a programme, an acoustic signal is activated 4 times, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. ). Only open the door once the wash cycle has terminated (caution: danger of scalding from steam) and press the OFF button to switch the dishwasher off. Unload the lower rack before the upper one. Close the water tap. Upper and lower rack Crockery holders: • Down: cups and long-stemmed glasses. Up: plates. Lower rack A A • Upper rack C “Vario Organizer” multi-purpose support: To be used, for example, for long-handled utensils (arrange knives with the blade facing downwards), cups and glasses. • May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). (See “Care and Maintenance” chapter in the user instructions). • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted?• Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?(See “Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). [. . . ] Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. Do not put liquid fat in the dishwasher (e. g. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]